Guangzhou Andy Stage Lighting And Sound Equipment CO.Ltd:LED PAR64 RGB、ledwash、575 Wash、575 Spot、1200 Spot、ColorSpot 1200、Robin 300E Wash
 
  网站首页 公司简介 产品展示 工程展示 行业新闻 人才招聘 在线咨询 联系我们
 
 LED series
 Moving head light series
 Film and theatre lighting series
 Follow light series
 Outdoor light series
 Fog machines
 Strobe light series
 Stage light series
 Laser light series
 Controller series
 accessories series
 
News content
8 little knowledge of professional stage lighting sound
Source:ANDY         Time:2019-3-3 11:09:23

1, equipment shell charged phenomenon check sequence

Equipment shell charged - power supply line is damaged - line phase is correct - equipment grounding is correct - the use of voltage is correct.

2, the sound system volume

The device volume is insufficient, the amplifier and speaker line level settings are correct - speaker wire connection is solid - phase power amplifier and speakers are the same, the attenuation of the appropriateness of the equalizer.

Resonance and feedback 3, sound field.

Resonance sound feedback - check the room response whether peak - room structure and decoration is reasonable, the crossover point and low gain is reasonable, the reverberation time is too long.

4, the interference noise

Audio system with noise and light interference - sound and lighting power is separated and light power and control lines are from the audio signal line too close - silicon box is too close from the audio equipment.

Speaker whether shielded transmission noise signal is reasonable, all signal lines properly grounded signal is correct - power phase all audio equipment is consistent.

5, the light is out of control

Lights out - controller program is correct - address code lamp is correct - connection control line is correct - shielding control line is bad or interference - lamp spacing adjustment is appropriate, the light electricity switch contact is good.

6, computer light bulbs are often damaged (750 hours)

A light bulb is easy to bad installation is reliable if contaminated dust and moisture - bulb heat is good - voltage is normal, if the power switch frequent operation.

7, the video image is not normal

Video image is not normal and program modes is correct - equipment enclosures are charged - signal shielding are high level interference - projector is normal - projection lamp performance is inferior.

8, a wireless microphone sound instability

The sound is not stable, whether the system has the high frequency interference source and antenna connection is correct - receiver tuning is correct and microphone and microphone quantity is excessive battery power is insufficient

 Previous: What is the advantage of the 280W beam
 Next: Philips will exhibit a stage lighting solutions
  Links
 
About Us | News | Recruitment | Advisory | Contact Us
All rights reserved:Guangzhou Andy
粤ICP备17021536号-1